Cookie Consent, meet your website.

Ensure your website complies with cookie laws, enhancing user privacy and trust.

Add Cookie Consent to your site

Start with Cookie Consent

Sign in to Cookie Consent and find the embed code for what you want to show. Some plans don’t include embedding, so check yours.
Paste it. Place it.

Paste the code into your Pagecloud AI chat and say where it should go, like “Add this to the Contact page, under the address.” If Cookie Consent says where the code belongs, such as the page header, mention that too.
Make sure it works

Check the page on desktop and mobile. Some tools only show their embed once you add your website’s address in their settings.

Cookie Consent is a third-party service. It runs on your Cookie Consent account, which manages its own data, settings and subscriptions.

Pagecloud Classic setup steps

For sites built with Pagecloud Classic, our original builder.

To Add Cookie Consent onto your PageCloud Site

Head to Cookie Consent builder here.
Adjust Cookie Consent to make it your own.
Copy the code provided on the right side of the page.
On the page you want to display the Cookie Consent, open the <head> editor.
Paste the code provided at the bottom of the <head> editor before the closing </head> tag.
Click "Save & Close" then Save the Page.
When Navigating to the page, the Cookie Consent will now appear.

Good to know

What’s an embed code?

A short piece of code a tool gives you so its content can appear on another website, such as a booking form, a video, a map or a sign-up form. The tool keeps running it; your page shows it.

Where do I find it?

In the tool’s settings, usually under Share, Embed or Install. If you can’t spot it, search the tool’s help center for “embed”.

Will it add cookies to my site?

Some tools do. If yours does, your site’s cookie or privacy notice may need to mention it. The tool’s help center will say what it uses.

Can I change or remove it later?

Yes. Ask Pagecloud AI to move it, swap in new code or take it off the page.

What if my tool isn’t listed?

If it gives you an embed code, the same steps apply. Browse all integrations to see what’s covered.